|
Series 2400 modular vacuum
conveying equipment is designed to move powder, pellet, regrind, or granular
material with equal ease and efficiency. This versatility results from
interchangeable component options in the unit’s material of construction,
power, filter, and receiver inlet sections. This also makes it easy
to adapt the equipment to future applications.
Features:
- Materials
of construction
Receivers are available in aluminum or 316 stainless steel. Since receiver
sections are interchangeable, receivers can be specified with stainless
steel material contact areas only.
- Choice of power source
You can choose between a self-contained vacuum source mounted in the
receiver’s lid, or a central system vacuum blower. Self-contained
units (loaders) work well as independent single stations where material
is moved a short distance to one destination. Central system receivers
utilize a common vacuum blower package, and are primarily used on multiple
destination applications where larger conveying rates or long distances
are required.
- Heavy-duty discharge spout
Each
receiver is equipped with a heavy-duty, cast discharge spout and one-piece
stainless steel gate. A rubber seal is positioned on the spout and makes
a positive seal with the during the draw cycle. It is designed to withstand
high temperature applications for loading drying hoppers.
Each
section of the receiver is attached by quick-connect clamps to facilitate
filter maintenance and receiver cleaning. Additionally, this provides
variable rotation of each section to allow the receiver’s inlet
and outlet to be positioned for proper installation.
A Hall
Effect-based magnetic level-sensing system, located on the top side
of the unit’s mounting flange, requires no wires in the product
zone. It signals the controls that another load of material is required
when the discharge gate closes.
 Single
or dual inlets
Single
or dual inlets with tangential entry for efficient material/air separation
are available. Single inlets have a check valve to permit more than
one receiver to draw material from a common conveying line. Dual inlets
allow the receiver to accept product from two material sources in an
operator defined ratio. For example, the receiver could draw virgin
material with one inlet and regrind with the other. The ratio is controlled
at the Central Controller.
| Filters designed
to meet your specific applications |
| |
 Pellet
receiver filters
The
pancake foam filter is ideal for handling clean material such as
pellets, where the need
for filtration is minimal. |
 Perforated
aluminum filter
is specified for applications where the removal of fines is important.
As the first in a two-stage system, the perforated aluminum filter
retains large particles in the receiver, allowing the fines to be
collected downstream in the in-line filter.
|
|  Static
bag filter
The
static bag filter is included in the Regrind Receiver. It consists
of a group of cloth bags providing more filter area for use with
regrind or pellets containing fines. |
 Self-cleaning
bag filters
The Powder Receiver uses
the static bag filter element with pulse cleaning added. The filter
bags are cleaned automatically with bursts of compressed air after
each draw cycle. This reduces manual filter cleaning and makes the
powder unit ideal for handling powdered or granular material. The
self-cleaning unit can also be used in pellet applications where manual
filter cleaning is restricted by the unit’s location. |
For more information, contact
Premier.
 PDF Download
2410 Receiver Dimensional
2415 Receiver Spec Sheet
If you need the free Acrobat Reader, click
here.
|
